Hello friends. So, you intend to add a new wall mounted vanity unit. It is not as hard as you think if you do not consider yourself a handyman or a handywoman. Do not overburden it as “jobs or work,” but it is an adventure. The vanity is normally installed with the back wall by screws and the plumbing sink is made by turning the heat and cold-water valve by cutting off both lines and one drainpipe. Between the top of the vanity and the wall might be some caulking. With a razor knife, the particles can quickly be removed.
Your new bathroom vanity units will be either flat-packed or built-in, and you can advise whether you are supposed to install the unit by using the product description online or in-store. It should be easier enough if self-assembly is needed and all necessary tools as part of the furniture kit are to be supplied. If your vanity system is much too big to match the bathroom door, keep it in position.
Main steps to follow
- Here is the presumption that if you have one of your old wall mounted vanity units, your supply of water and waste pipes have been removed and some new floor has been fitted. Before the old unit is replaced, you shut off the supply of water to hot and cold pipes that support the vanity unit, or you shut off the supply into the building.
- Start with an assessment of the zone. You will have to cut a hole to a residence on the base of the unit if the water tubes and waste passes from the floor under which the vanity unit is to be placed. when these pipes are created on the wall, you must cut the accompanying hole behind the unit.
- For this purpose, it would very likely be already possible for holes in your vanities device that are built to fit the inset or a counter basin. If a countertop basin and vanity unit have been bought, you should have left the top of the unit whole, so you can determine exactly where you would like the basin and the taps to sit.
- Take note of the old rule ‘measure twice, cut one time’ when you cut your holes: if you mistakenly place a hole in the wrong spot or cut a hole, it is impossible that the supplier will take mercy for you and give you a refund. Sand down your new holes roughly and wipe the entire unit off to complete this point.
- You will be able to mount your vanity unit to the wall when it is ready. Again, calculate attentively and only drill if you are certain. A standing object can support its own weight from inside the wall, but you may want a helper or two for weight support.
- Plumbing next. If your taps belong to the range of the bowl they must be tightly linked to the vessel before being placed and the pipe itself installed. However, once the basin is in operation, a deck-mounted tap can be placed separately.
- The basin waste is fitted to the waste disposal pipe in a similar way. Make sure you follow those installation directions with your components and do not hesitate to employ a plumber if you are not certain – any errors might become costly as regards your bathroom water damages.
Your new wall mounted vanity units should be connected to the wall and the supply of water and waste should plumb into it. Using silicone sealant to screen the limited distance between the vanity edge and the wall. Then, carefully check whether there are no leaks while the unit is being loaded with water.
Conclusion
The installation of new vanity units improves storage and helps to keep the space free of clutter. Some other option is to replace existing facilities with something more appealing and newer. A variety of colors, designs, and finishes ought to be selected, including antique finishes and cabinets with mirrored doors to create a sense of space in a bathroom.
In the UK market, the Royal bathrooms is one of the very celebrated retailers for the reliable linage of entire washroom. Free home delivery and exchange policy is also in the cart. Have fun!